How to assemble a milling cutter?

Watch the video

How to assemble a milling cutter?

This article is useful to those summer residents who wish to try to assemble a milling cutter on a motor-block. And you can do it without outside help.

What is a milling cutter and how to assemble it?

Before you figure out how to assemble a mill, you needsay that this is one of the most important details in the motoblock. This attachments must always be fully operational. An important point - when assembling it is necessary to remember that the ground must cut a sharpened part of the blades.

To assemble a milling cutter on a motor-block, you need to know thatit is attached to the axis of the output shaft. To fix it, the villager needs a stopper. And since it's very difficult to do all the actions on your own, it's also good to stock up on the goats (the ideal size is 50 cm).

Step 1. Motoblock

For the convenience of the motoblock it is necessary to lean against a solidsurface (angle of inclination approximately 45 °). Trays for stability of construction are put under the handle. Now we need to remove the wheel. Only now it is possible to start assembling the milling cutter itself and installing it on the motoblock.

Step 2. Milling cutter

At this stage, it will be exactly how to assemble the milling cutter. Since their designs are completely different, then the way of assembly will be different. However, the principle will still be preserved.

Blades should be inserted into special slotsand screwed with bolts. Here it is important to place the cutting edge of the petal correctly - it should stand in the direction of motion and pierce with a sharp end to the ground. Some manufacturers on the blades themselves give a clue how to screw them (R - on the right side, L - on the left).

The additional section is attached to the main section by means of a pin.

The restraining disk is connected to the rest of the structure with a bolt.

Step 3. Finishing

At this stage, the milling cutter is inserted into the motor block, the wheel is placed in place. The product is ready for use.

Tips & Tricks

  1. The number of blades for the cutter depends on the power of the motor block itself. They can not be set more or less than necessary.
  2. For assembly, one or more axes can be provided. The assembly of the 4-blade cutter has the following feature - successive alternation of the right and left cutters on the mounting plate.
  3. More useful information is presented in our section - Household advice.

Related news

How to assemble a milling cutter

How to assemble a milling cutter

How to assemble a milling cutter

How to assemble a milling cutter

How to assemble a milling cutter

How to assemble a milling cutter

How to assemble a milling cutter

How to assemble a milling cutter

How to assemble a milling cutter

How to assemble a milling cutter

How to assemble a milling cutter How to assemble a milling cutter How to assemble a milling cutter How to assemble a milling cutter How to assemble a milling cutter How to assemble a milling cutter How to assemble a milling cutter How to assemble a milling cutter How to assemble a milling cutter How to assemble a milling cutter How to assemble a milling cutter How to assemble a milling cutter How to assemble a milling cutter How to assemble a milling cutter How to assemble a milling cutter How to assemble a milling cutter How to assemble a milling cutter How to assemble a milling cutter How to assemble a milling cutter How to assemble a milling cutter How to assemble a milling cutter How to assemble a milling cutter How to assemble a milling cutter